350-025 Exam
CCIE Service Provider Dial
- Exam Number/Code : 350-025
- Exam Name : CCIE Service Provider Dial
- Questions and Answers : 400 Q&As
- Update Time: 2011-09-21
- Price:
$ 119.00$ 69.00
Free 350-025 Demo Download
Test4pass offers free demo for CCIE 350-025 exam (CCIE Service Provider Dial). You can check out the interface, question quality and usability of our practice exams before you decide to buy it. We are the only one site can offer demo for almost all products.
Exam Description
It is well known that 350-025 exam test is the hot exam of Cisco certification. Test4pass offer you all the Q&A of the 350-025 real test . It is the examination of the perfect combination and it will help you pass 350-025 exam at the first time!
Why choose Test4pass 350-025 braindumps
Quality and Value for the 350-025 Exam
100% Guarantee to Pass Your 350-025 Exam
Downloadable, Interactive 350-025 Testing engines
Verified Answers Researched by Industry Experts
Drag and Drop questions as experienced in the Actual Exams
Practice Test Questions accompanied by exhibits
Our Practice Test Questions are backed by our 100% MONEY BACK GUARANTEE.
Cisco CCIE 350-025 exam braindumps questions and answers
¡¡
Exam : Cisco 350-025
Title : CCIE Service Provider Dial
1. What command is used to set the length of time a non-ISDN interface stays down after a call has been completed or has failed and before it is available to dial again?
A. dialer enable-timeout
B. dialer holddown
C. dialer fast-idle
D. dialer idle-timeout
E. dialer wait-for-carrier-time
Answer: A
2. To have the router verify a called-party number in the incoming setup message for an ISDN BRI call:
A. Use isdn tei first-call
B. Include ldn on spid number line
C. Use isdn answer1
D. Use isdn caller
Answer: C
3. The configuration register does NOT retain settings for:
A. An enabled 'Break' key
B. The console baud rate
C. The boot method
D. An enabled AUX port
Answer: D
4. Select the group of technologies which are listed in descending order of bandwidth scale:
A. SDH, X.25, ATM
B. DWDM, SDH, Frame Relay
C. DWDM, SDH, ATM
D. ATM, DWDM, Frame Relay
Answer: C
5. The network administrator has forgotten the enable password of the router. Luckily, no one is currently logged into the router, but all passwords on the router are encrypted. What should the administrator do to recover the enable password?
A. Call the Cisco Technical Assistance Center (TAC) for a special code that will erase the existing password.
B. Reboot the router, press the break key during bootup, boot the router into ROM monitor mode, and modify the configuration register so that the current configuration is ignored during normal bootup
C. Reboot the router, press the BREAK key during bootup, and boot the router into ROM Monitor mode to erase the configuration, and re-install the entire configuration as it was saved on a TFTP server.
D. Erase the configuration, boot the router into ROM Monitor mode, press the BREAK key, and overwrite the previous enable password with a new one.
Answer: B
6. While entering commands on a console, the break key is pressed accidentally and the router reboots. What action could disable this problem?
A. In configuration mode, enter disable break.
B. In configuration mode, enter no service break.
C. Change the configuration register.
D. Replace the router - this is an invalid response to pressing the break key when past 60 seconds after boot.
Answer: C
7. What type of fiber-optic system is used to distribute cable television signals?
A. Point to multipoint
B. Local Area network
C. Switched
D. Point to point
Answer: A
8. interface Dialer1
ip address 1.1.1.1 255.255.255.0
encapsulation ppp
dialer remote-name Smalluserdialer
string 4540
dialer pool 3
dialer-group 1
What statement about this configuration is true?
A. This interface is configured for legacy DDR and therefore cannot be used for dialer profiles.
B. This interface is a logical interface whose configuration is only used for inbound calls on physical interfaces in pool 3.
C. This logical interface belongs to a group of physical interfaces in group 1.
D. This configuration is not valid because it is missing the "dialer in-band" command.
E. This interface will use the name Smalluser instead of the router's hostname for authentication purposes when connecting to the remote peer.
F. None of the above
Answer: F
9. The Hold-Down Timer used in Distance Vector protocols:
A. Sets the time limit of how long a router may keep a packet in its buffer, if the routing protocol is in the process of converging
B. Determines the number of seconds a router will wait before sending another update to neighbor routers
C. Sets a specific period for routers to neither accept or advertise a route from a destination where an original route was recently lost
D. Sets a duration where routes are not accepted from the neighbor router that caused a routing loop
Answer: C
10. For an OC-48 signal (2.5Gb/s), what is the BER (bit error rate) if there is 1 bit error every four days?
A. 10E-12
B. 10E-13
C. 10E-14
D. 10E-15
E. 10E-16
Answer: D
11. What effect will this configuration command have?line vty 0 4no password vtypassword
A. All telnet connections to the router will be denied.
B. Only one telnet connection at the router will be allowed at a time.
C. Virtual terminal sessions will not be able to enter enable mode.
D. Virtual terminal sessions will not be asked a user-level password.
E. It will have no effect.
Answer: A
12. The purpose of the dialer fast-idle command is:
A. To decrease the amount of time that an interface is kept down before the next call can be placed - By default, DTR is held low for five seconds.
B. To specify the amount of time that an interface can remain idle before being disconnected when new outbound calls need to be made
C. To decrease the interdigit delay between DTMF tones when placing a call
D. To increase the rate at which disconnected interfaces become available for new outbound calls
E. To specify the regular idle timeout for high speed non-async interfaces
Answer: B
13. On a Cisco router with an external modem, what EIA 232 signal will be received by the access server to indicate the presence of an incoming call?
A. Request To Send
B. Clear To Send
C. Data Terminal Ready
D. Data Set Ready
E. Loopback
Answer: D
14. Look at the router configuration above. If this router has a configuration-register setting of 0x102, select the proper boot sequence:
A. The router will try to use the image "rsp-isv-mz.112-8.P" on slot 0, then attempt to boot from a network server, and finally boot from ROM.
B. The router will try use the image "rsp-isv-mz.112-8.P" on slot 0, then attempt to boot from any other valid image in flash, and finally boot from ROM.
C. The router will try to use the image "rsp-isv-mz.112-8.P" on slot 0, and then it will boot from ROM.
D. The router will try to use the image "rsp-isv-mz.112-8.P" on slot 0, and then attempt to boot from a network server.
Answer: A
Click Online chat to talk with us , get more informations about Cisco CCIE 350-025 practice exam study guides questions and answers
Test4pass 350-025 Exam Features
Quality and Value for the 350-025 Exam
Test4pass Practice Exams for Cisco 350-025 are written to the highest standards of technical accuracy, using only certified subject matter experts and published authors for development.
100% Guarantee to Pass Your 350-025 Exam
If you prepare for the exam using our Test4pass testing engine, we guarantee your success in the first attempt. If you do not pass the CCIE 350-025 exam (ProCurve Secure WAN) on your first attempt we will give you a FULL REFUND of your purchasing fee AND send you another same value product for free.
Cisco 350-025 Downloadable, Printable Exams (in PDF format)
Our Exam 350-025 Preparation Material provides you everything you will need to take your 350-025 Exam. The 350-025 Exam details are researched and produced by Professional Certification Experts who are constantly using industry experience to produce precise, and logical. You may get questions from different web sites or books, but logic is the key. Our Product will help you not only pass in the first try, but also save your valuable time.
350-025 Downloadable, Interactive Testing engines
We are all well aware that a major problem in the IT industry is that there is a lack of quality study materials. Our Exam Preparation Material provides you everything you will need to take a certification examination. Like actual certification exams, our Practice Tests are in multiple-choice (MCQs) Our Cisco 350-025 Exam will provide you with free 350-025 dumps questions with verified answers that reflect the actual exam. These questions and answers provide you with the experience of taking the actual test. High quality and Value for the 350-025 Exam:100% Guarantee to Pass Your CCIE exam and get your CCIE Certification.
Test4pass 350-025 examTest4pass 350-025 pdf exam
Test4pass 350-025 braindumps
Test4pass 350-025 study guides
Test4pass 350-025 trainning materials
Test4pass 350-025 simulations
Test4pass 350-025 testing engine
Test4pass 350-025 vce
Test4pass 350-025 torrent
Test4pass 350-025 dumps
free download 350-025
Test4pass 350-025 practice exam
Test4pass 350-025 preparation files
Test4pass 350-025 questions
Test4pass 350-025 answers
http://www.test4pass.com/350-025-exam.html The safer.easier way to get CCIE Certification
.
My Shopping Cart
